Mindray TRIO Instruções de Operação descarregar pdf (Página 40)

Trio™ Operating Instructions 0070-10-0666-01 2 - 11

Operations System Menu

2.3.5.6 Trace Setup

TRACE SETUP allows the user to choose the traces that will be displayed in the waveform

area and to choose the viewing mode. The viewing modes improve the viewability of the

display depending on how the Trio is positioned for use. There are two viewing modes that

can be selected from the WAVE DISPLAY pull-down menu.

• MODE 1 – provides an enhanced view angle and a less smooth wave. This mode should

be used when the Trio is being viewed from an angle. In most instances, this mode will

provide optimal viewing of waveform data. (MODE 1 is the factory default setting.)

• MODE 2 – provides a basic view angle and a smooth wave. This mode should be used

when the Trio is wall-mounted and being viewed from below.

1. Select TRACE SETUP from the MONITOR SETUP menu. The TRACE SETUP menu

(FIGURE 2-10) is displayed.

FIGURE 2-10 Trace Setup Menu

2. Use the Navigator™ Knob to select each parameter waveform (a check mark in the box

next to a parameter indicates that it has been selected). To deselect a parameter

waveform, press the knob again.

3. Choose the desired viewing mode from the WAVE DISPLAY pull-down menu.

4. Select PREVIOUS MENU to return to the previous menu. Select NORMAL SCREEN

(from the menu or the Front Panel Keypad) to exit the menu and return to the normal

screen.

NOTE: If the optional IBP is not installed, it will not be provided as

a choice in the TRACE SETUP menu.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 169 170

Sem comentários

Mindray TRIO Instruções de Operação Página 40