Mindray DPM 1 Manual do Operador descarregar pdf (Página 43)

4-3

In the following circumstance, the setting of ALARM VOL may be lower than the

setting of MIN ALARM VOL. In this case, ALARM VOL is automatically adjusted

according to MIN ALARM VOL.

 Select SYSTEM SETUP→MAINTAIN→USER MAINTAIN; enter required

password; and then change MIN ALARM VOL in the pop-up menu.

 Select SYSTEM SETUP→DEFAULT; and then select LOAD FACTORY

CONFIG or LOAD USER CONFIG in the pop-up menu;

 Restart the monitor after turning it off for more than 120s;

 Change patient ID;

 Change patient type.

 KEY VOL 0 to 10

 PULSE VOL 0 to 10

 LCD BRIGHT 1 to 10

 LCD CONTRAST 1 to 10

 NIBP UNIT mmHg, kPa

When the key volume or pulse volume is set to 0, it indicates that the key tone or pulse tone

is disabled.

4.2.2 Network Setup

In the SYSTEM SETUP menu, select NET SETUP. In the NET SETUP menu, you can set

the following items.

 NET TYPE: CMS, CMS+

 LOCAL NET NO.:It indicates the bed number of a monitor in the monitoring network.

If the NET TYPE is CMS, the LOCAL NET NO can be set between 1 and 64; if the

NET TYPE is CMS+, it can not be set.

 IP ADDRESS SETUP: When the monitor is connected with the central monitoring

system, and the NET TYPE is CMS+, you can set the IP address for your monitor .

The network type and local net No. are related to the central monitoring system (CMS) to

which the monitor is connected. Contact the CMS technical personnel for any doubt.

WARNING

 This monitor is intended for use only by clinical professionals or under their

guidance. It must only be used by persons who have received adequate training

in its use. Anyone unauthorized or untrained must not perform any operation

on it.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 119 120

Sem comentários

Mindray DPM 1 Manual do Operador Página 43